SS2/SparcPrinter watchdog resets

2007-12-25 7:45:00

My original Query was (Summary and fix is below).

----- Begin Included Message -----

>From sun-managers-relay@delta.eecs.nwu.edu Fri May 8 14:27:54 1992

Sender: sun-managers-relay@eecs.nwu.edu

To: sun-managers@eecs.nwu.edu

Subject: SS2/SparcPrinter watchdog resets

Content-Length: 980

X-Lines: 30

Sun-managers:

System: SS2, 4.1.2, OW3.0, NewsPrint 2.0

Has anyone had problems with a SPARCPrinter with NewsPrint 2.0

on a SS2 running 4.1.2 when printing, especially

Sun rasterfiles (more often on the second print job after

a reboot).

Our's crashes the system routinely with a "Watchdog Reset"

caused by a Window Underflow".

The machine and printer are brand new, the CPU and S-bus

board for the Printer have been replaced and Sun still

can't figure out what's wrong. Any suggestions or

similar circumstances??

BTW: The machine is fine with the S-Bus board out of the

machine. Then again, this makes the printer an expensive

door stop :(

======================= SUMMARY ===========================

After many weeks waiting for Sun to figure out the problem

it turned out to be a CPU board revision problem that didn't

like some SBUS boards.

Some SS2 CPU boards contain a "AT&T cache chip" that caused

the Watchdog reset problem (and sometimes a Panic:

Data Fault) when there is an additional

SBUS board in the system.

Ours was originally a brand new SS2. We had already replaced the CPU

once, but evidently Sun sent us another CPU board with the

same AT&T chip on it.

So far (about two days) everything is working and we have had

no further crashes.

Thanks to our local (Minneapolis) field service people for

figuring out the problem. Evidently, Sun Support

West or East hasn't heard of the problem yet since we had

been working through both on the problem for weeks.

\------------------------------------------------------------\

 \ Bruce Kall \ Internet: Kall@Mayo.edu \

  \ Mayo Clinic (Foundation) \ Phone: (507)-255-4768 \

   \ Rochester, MN 55905 \ \

    \------------------------------------------------------------\

Comments

Got something to say?

You must be logged in to post a comment.