JNI with T3+ array
2007-12-24 23:27:00
We are using V880 and T3+(with 2G Fiber interface). PCI based JNI 146 has been
installed on this V880.
After booting up the system, from the OK prompt, I can see the JNI interface &
T3+ array. However after the OS up, I can't find the array in format output even
though I can see that the array has been found during the system booting
procedure.
I have tried the following ways:
1.rebuild the /etc/path_to_inst
2.install the SUNWsan to probe array
3.manually create the device tree pointed to this array
No luck so far! Appreciate any suggestions! I will summarize if solution found.
Thanks & have a good day,
carl
Comments
Got something to say?
You must be logged in to post a comment.
